The Airflow iCON60 high power fan is most suited to large bathrooms and kitchens.
Finish: White as standard but has a range of optional coloured front covers to suit the decor in your room.
Controls: To get the best out of your iCON60 fan a range of additional plug-in modules are available to add pullcord, timer, humidity and PIR occupancy sensor control. The fan will also work fine in a simple on/off mode without the addition of any modules if you prefer. The fan can be either wired to come on with your room light or a separate remote switch.
Shutter: The favourite feature on the iCON range is the futuristic, gradually opening iris shutter. This extremely neat feature prevents back drafts coming back into your room when the fan isn't in use. There is a short delay before the shutter opens once the fan has started up, this is normal.
Which module should I use?
Humidity (HTM) - Monitors the humidity in your bathroom and switches the fan on and off as required to control it. Also incorporates an overrun timer which allows the fan to run on for a while after the room light is switched off. The module also comes with a pullcord to allow local manual switching of the fan for the duration of the timer setting. Both the humidity level and the timer can be easily adjusted to suit your needs.
Timer (TM) - An overrun timer which allows the fan to run on for a while after the room light is switched off.
Pullcord (PCM) - Allows local manual switching of the fan.
PIR/Timer (PRTM) - Switches the fan on when someone walks into the room. When they leave the room, the fan runs on for the duration of the timer setting. The module also comes with a pullcord to allow local manual switching of the fan for the duration of the timer setting.
PIR/Humidity/Timer (PRHTM) - Same as the PRTM module but with additional humidity control (As you could easily leave the room when its full of steam).
- Ductable over 4M.
- Wall/ceiling/panel mounting.
- Performance 72 litres per second which is 260 metres cubed per hour.
- Fan size 280x55mm.
- Duct Size 150mm (Requires 190mm hole to a depth of approx 100mm to flush mount)
- Supply 230V.
- IPX4 Splashproof.
- Sound pressure 44.5dB(A) at 3M.
Easy Installation - A quick, core drilled hole enables immediate fixing of the fan. The twist on/off cover requires only a single side entry fixing screw. Cantilever fixing lugs enable recessed installation on uneven surfaces.
Supplied with a narrow contour skirt for optional surface mounting.
Flush Fitting - Hole Size - 190mm to a depth of approx 100mm to accept motor body then 160mm for ducting
Surface Fitting - Hole Size - 160mm